Constant hood height for a maximum capture volume.
Self-supporting construction without visible attachment or sharp edges for cleaning without risk of injury.
Side reinforcement, 15/10mm galvanized steel, height 50mm, integrated into the hood, ensuring the rigidity of the assembly.
Setting the level from inside the hood and clip-in fastener caps.
Braced at sensor end for rigid join between two modules, while allowing a large air passage.
Visible faces austenitic stainless steel AISI 304 (1.4301) with a brushed finish SB.
- Central hoods assembled back to back using two hoods backed with partitions.
- Sides without obvious elements such as rivets and studs.
- Rear and upper surfaces in galvanized steel.
- Standard filter galvanized material, stainless steel frame M0397x472x25 mm.
- Stainless steel closure plate.
- Peripheral gutter.
- Drain with stainless steel - threaded plug Gas 1/2.
Packaging: Packaged on pallet in heat-shrink film.
On request
- Rear assembly plate without visible screws and top panel in stainless steel.
- Longer and special lengths available.
- Accessories (ring plate, balancing guillotine damper, waterproof light etc.).
-Motorised hoods, laundries, ovens, comfort, comfort 90/10, 30 to 60% induction, closed filter ceilings, modular ceilings etc.
